Selective Laser Sintering (SLS) 3D Printer

This Request for Proposal (RFP) supersedes #W6399-27-SS20, due to a change in dollar amount, and the impact on trade agreements, a new solicitation has been created to reflect the changes. The Department of National Defence has a requirement for up to three (3) Selective Laser Sintering (SLS) 3D Printers intended for high-performance manufacturing applications, such as prototyping, tooling and production of end-use parts composed of thermoplastic polymer powders. This procurement process is intended to result in the acquisition of up to three (3) SLS 3D Printers. The equipment being bid in this requirement must fully comply with the Technical Specifications within the Request for Proposal solicitation document. The deliverables are required no later than March 31, 2027. The Crown retains the rights to negotiate with suppliers on any procurement. Documents may be submitted in either official language of Canada.

Category: GD

• Procurement method: Competitive - Open bidding
• Briefing session: Not captured. Check the original notice before relying on this.
• Eligibility and evaluation: set out in the tender documents. Check mandatory returnables, registrations and scoring before you commit.

The tender pack is published with the original notice. Use “Download Tender Pack” to open it.

Published

23 Sept 2026

First seen by Atlas

29 Sept 2026

Briefing session

Not captured. Check the original notice before relying on this.

Submission deadline

02 Nov 2026, 15:00 SAST

Estimated value

Not stated in the notice

Contract type

Competitive - Open bidding

Category

GD

Source

CanadaBuys

• Manage the Bid: A structured response, from the opportunity decision to the final submission.
• Develop the Response: Clear writing, considered production and approved material ready for reuse.
• Build Bid Capability: Practical support that strengthens how your business prepares and responds.